Citel EXTender 3000 Guide d'installation télécharger pdf (Page 15)

EXTender 6000 Quick Installation Guide 15

VT-100 Setup

Make sure the EXTender is connected as shown on page 12.

You must use communications software — for example, HyperTerminal — to configure and test the

EXTender. Attach one end of the RS-232 cable to your PC COM port and the other end to the DB-9

Console port connector on the front of the EXTender.

Set up HyperTerminal as follows:

Access: Start button > Programs > Accessories > HyperTerminal folder > HyperTerminal

icon.

When prompted for a name, type gateway and click OK.

(Determine what port [n] you will connect to on your pxc. At the Telephone Number dialog,

select Connect using = Direct to COMn (ignore other settings) and click OK.

At the COMn

Properties dialog, set the parameters to 9600, 8, none, 1 and Xon/Xoff

and click OK.

When the HyperTerminal window appears, it is blank; that is, there is no logon prompt.

Click on File, then Properties. Select Settings tab and go to Emulation window. Select

VT100 and click OK.

n is the number of the COM port on the PC.

Go to Power-Up sequence on the next page.

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 42 43

Pas de commentaire

Citel EXTender 3000 Guide d'installation Page 15